TM 5-3805-261-34
ENGINE MAINTENANCE.
3-7.
Timing Gears and Plate. (Sheet 2 of 9)
REMOVAL
1.
Loosen bolt (1) on gear (3,
Figure 3-19) approximately .25
inch.
2.
Using a bearing puller, loosen
gear (3) from shaft.
3.
Remove bolt (1), washer (2) and
gear (3, Figure 3-20).
4.
Remove two bolts (4), plate (5)
and gear (7, Figure 3-21).
NOTE
If maintenance is required, use an
arbor press to remove bearing (6)
from gear (7, Figure 3-22).
Go to Sheet 3
3-39
Figure 3-19.
Figure 3-20.
Figure 3-22.
Figure 3-21.