ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_113

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_115

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
69

TM 5-3805-261-34 ENGINE MAINTENANCE. (cont) 3-7. Timing Gears and Plate. (Sheet 5 of 9) INSTALLATION (cont) CAUTION After plate is installed, be sure rack is free to move in fuel injection pump housing. Poorly positioned preformed packing on drive end of pump can hold rack and prevent move- ment. Observe movement through hole (A) in plate. If rack does not move freely, remove plate and properly position fuel injection pump housing preformed packing. 5. Position gear (9) on camshaft so that "C" marks on gear (9, Figure 3-27) and crankshaft gear are aligned. 6. Install four bolts (8) to secure gear (9, Figure 3-28). Tighten four bolts (8) to 41 + 5 ft-lb torque. 7. Install bearing (6) in gear (7, Figure 3-22). The end of the bear- ing must be .60 inch below the face of the gear hub. NOTE Before installing gear, make sure that oil hole in the shaft for gear is open. 8. Install gear (7, Figure 3-21). 9. With finished side of plate (5) toward gear (7), install plate (5) and two bolts (4). Go to Sheet 6 Figure 3-27. Figure 3-28. Figure 3-22. Figure 3-21. 3-42

Privacy Statement
Press Release
Contact