TM 5-3805-261-34
ENGINE MAINTENANCE. (cont)
3-4.
Engine. (Sheet 12 of 13)
INSTALLATION (cont)
30.
Position governor control
assembly (20, Figure 3-5) on
backside of engine front cover
between cover and fuel injection
pump.
31.
Position three washers (22) and
bolts (21) through front cover in
center mounting hole of governor
control housing mounting plate.
32.
Install clips (24 and 23), three
washers (22) and bolts (21)
securing hose, cables and
governor control housing to
engine front cover.
33.
Position linkage assembly (74) on
governor control assembly (20)
lever.
34.
Install pin (19) and new cotter
pin (18).
35.
Connect hose assembly (17) to
fuel transfer pump on right side
of engine.
36.
Connect hose assembly (34) to
fuel injection pump.
37.
Install clip (16), washer (15)
and bolt (14) securing three
starting motor cables.
Figure 3-5
Go to Sheet 13
3-28
Figure 3-15.
