ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE - TM-5-3805-261-34_95

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_97

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
51

TM 5-3805-261-34 ENGINE MAINTENANCE. (cont) 3-4. Engine. (Sheet 8 of 13) REMOVAL (cont) 42. Remove shim(s) (64) from front of frame, left and right sides. Tie shim(s) (64) together and tag for identification. 43. Remove two bolts (65) and nuts (66) from lower rear of engine, left and right sides. Note the number of threads on bolts (65) that extend above nuts (66) before removing. CLEANING Clean all parts. Refer to Chapter 2. INSPECTION Inspect all parts. Refer to Chapter 2. INSTALLATION 1. Install two nuts (66) and bolts (65, Figure 3-9) in rear engine mounts, left and right sides of engine. 2. Position shim(s) (64) in same location as removed to front of frame, left and right sides. 3. Attach hoist and sling. 4. Position engine and lower slowly. 5. Align flywheel with engine coupling gear. If flywheel and coupling do not engage, turn crankshaft hub mounting bolt at front of engine. This will turn flywheel, allowing gear teeth to engage. Go to Sheet 9 3-24 Figure 3-9.

Privacy Statement
Press Release
Contact