Figure3-7.Go to Sheet 11 3-26TM 5-3805-261-34ENGINEMAINTENANCE,(cont)3-4. Engine. (Sheet 10 of 13) INSTALLATION(cont)15. Install clip (55), washer (54) and bolt (53, Figure 3-8). 16. Install clip (52), washer (51 ) and bolt (50). Route engine wiring harness between engine block and oil gage tube. 17. Bring three wire assemblies (45, Figure 3-7) behind coolant tube for transmission oil cooler, located behind air compressor. 18. Connect tube assemblies (46 and 47) to oil sampling valve at rear of engine. 19. Connect three wire assemblies (45, Figure 3-7) on coolant temperature switches on front of engine. 20. Install three screws (44). 21. Install clip (43), washer (42) and bolt (41) on left side of engine. 22. Install clip (40), washer (39) and bolt (38) to supplemental steering motor mounting bracket. 23. Connect hose assembly (37) to air compressor governor on left side of engine. 24. Connect hose assembly (36) to air compressor.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
