TM 5-3805-261-20WIRING HARNESS MAINTENANCE. (cont)7-117.GeneralRepair. (Sheet 7 of 15)(5)Polarized connector, multi-wire.DISASSEMBLYNOTEAll wires must be tagged uponremoval from connector to aid ininstallation. Each tag must alsoindicate if the wire is connected to apin-type terminal or a socket-typeterminal.1.Using pin removal/insertion tool, push outconnector terminals of connector (Figure 7-195).2.Remove and discard connector terminals.Cut wires close to terminals.ASSEMBLY1.Strip wires, refer to chart (Figure 7-191).Do not cut or nick wire strands.2.Tin bare wires (Figure 7-195). Use resin-core solder to coat bare wires. If usingsolid core solder, clean wires with fluxbefore tinning.3.Insert wires in new terminals. Make surepin-type or socket-type terminals are usedas required.4.Crimp terminals securely to fasten wires toterminals.5.Using pin removal/insertion tool, install inholes of connector, as required.Figure 7-195Figure 7-191Go to Sheet 87-298
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business