TM 5-3805-261-20WIRING HARNESS MAINTENANCE. (cont)7-117.GeneralRepair. (Sheet 5 of 15)(3)Terminal type connector, pin and socket.(cont)ASSEMBLY1.Strip wire (4, Figure 7-191), refer to chart.Do not cut or nick wire (4) strands.2.Tin bare wires (4, Figure 7-193). Use resin-core solder to coat bare wires (4). If usingsolid core solder, clean wires (4) with fluxbefore tinning.3.Slide shell (3) onto wire (4).NOTENew terminal must be selected tomatch the size of the mating contactat the terminal connection. Newterminal must also match thecrimping area with the thickness ofthe wire.4.Insert wire (4) into new terminal (2).5.Crimp terminal (2) securely to fasten wire(4) to terminal (2).6.Install C-washer (1) on terminal (2).NOTETerminal shell is held in position overterminal by C-washer. C-washermust be firmly seated inside shell.7.Slide shell (3) up over new terminal (2) andC-washer (1).Figure 7-191Figure 7-193Go to Sheet 67-296
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business