TM 5-3805-261-20
WIRING HARNESS MAINTENANCE.
7-117.
General Repair. (Sheet 10 of 15)
(7)
Terminal-type connector, weather-proof.
ASSEMBLY
1.
Strip wire (4, Figure 7-191), refer to chart.
Do not cut or nick wire (4) strands.
2.
Tin bare wires (4). Use resin-core solder to
coat bare wires (4). If using solid core
solder, clean wires (4, Figure 7-197) with
flux before tinning.
3.
Slide shell (3) onto wire (4).
4.
Slide sleeve (2) onto wire (4).
NOTE
New terminal must be selected to
match the size of the mating contact
at
the
terminal
connection.
New
terminal
must
also
match
the
crimping area with the thickness of
the wire.
5.
Strip wire (4), refer to chart. Do not cut or
nick wire (4) strands.
6.
Tin bare wires (4). Use resin-core solder to
coat bare wires (4). If using solid core
solder, clean wires (4) with flux before
tinning.
7.
Insert wire (4) into new terminal (1).
8.
Crimp terminal (1) securely to fasten wire
(4) to terminal (1).
9.
Slide sleeve (2) over new terminal (1).
Figure 7-191
Go to Sheet 11
7-301