TM 5-3805-261-20WIRING HARNESS MAINTENANCE.7-117.GeneralRepair. (Sheet 2 of 15)(1)Terminal-type connectors, with shell.DISASSEMBLYRemove and discard defective terminal with shell(Figure 7-190). Cut wire close to shell.ASSEMBLY1.Strip wire, refer to chart (Figure 7-191). Donot cut or nick wire strands.2.Tin bare wires. Use resin-core solder tocoat bare wires. If using solid core solder,clean wires with flux before tinning.3.Strip new terminal wire. Refer to chart. Donot cut or nick wire strands.4.Tin bare wires. Use resin-core solder tocoat bare wires. If using solid core solder,clean wires with flux before tinning.5.Slide shrink tubing on wire before splicing.6.Splice wires. Twist wires tightly together.7.Solder wires. Secure wires to preventmovement; use solder sparingly.8.Position shrink tubing over spliced wires.9.Apply heat and shrink until snug.Figure 7-190Figure 7-191Go to Sheet 37-293
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
