TM 5-3805-261-20
WIRING HARNESS MAINTENANCE.
7-117.
General Repair. (Sheet 6 of 15)
(4)
Flag-type connector, terminal with shell.
DISASSEMBLY
Remove and discard defective terminal (Figure
7-194). Cut wire close to terminal.
ASSEMBLY
1.
Strip wire, refer to chart (Figure 7-191). Do
not cut or nick wire strands.
2.
Tin bare wires (Figure 7-194). Use resin-
core solder to coat bare wires. If using
solid core solder, clean wires with flux
before tinning.
3.
Roll back insulation on new terminal to
expose metal crimping area.
4.
Insert wire in terminal.
5.
Crimp terminal securely to fasten wire to
terminal.
6.
Unroll insulation on terminal to cover metal
parts.
Figure 7-194
Go to Sheet 7
7-297