TM 5-3805-293-23-5
0326
REMOVAL
000326
1. Disconnect blackout light connector (Figure 1, Item 12) from wiring harness connector (Figure 1, Item 11).
2. Remove tiedown strap (Figure 1, Item 2) from bracket (Figure 1, Item 1). Discard tiedown strap.
3. Remove two bolts (Figure 1, Item 5), washers (Figure 1, Item 4), clips (Figure 1, Item 5) and wiring harness
(Figure 1, Item 7) from bracket (Figure 1, Item 6). Position wiring harness aside.
4. Remove three bolts (Figure 1, Item 10), washers (Figure 1, Item 9), bracket (Figure 1, Item 6), and bracket
(Figure 1, Item 1) from tiedown assembly (Figure 1, Item 8).
.
Figure 1. Blackout Light Bracket.
0326
5. Attach sling and lifting device to tiedown assembly (Figure 2, Item 3).
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure that any lifting device used is in good condition and
of suitable load capacity. Keep clear of heavy parts supported only by lifting device.
Failure to follow this warning may result in injury or death to personnel.
N OT E
Tiedown assembly weig s 482 lb (219 kg).
h
Upper right and left bolt holes on front frame are slotted to allow tiedown assembly
mounting bolts to slide out when tiedown assembly is lifted.