TM 5-3805-293-23-3
0114
INSTALLATION CONTINUED
C AU T I O N
Fuel injectors must be installed in original location marked at removal. Failure to follow this
caution may result in damage to equipment.
20. Install six fuel injectors (Figure 28, Item 1) and clamps (Figure 28, Item 6) on engine (Figure 28, Item 8).
21. Install six new torx bolts (Figure 28, Item 7) on clamps (Figure 28, Item 6). Finger tighten bolts.
22. Install new gasket (Figure 28, Item 9), valve cover base (Figure 28, Item 2) and 14 bolts (Figure 28, Item 5) on
engine (Figure 28, Item 8). Finger tighten bolts.
C AU T I O N
Original fuel lines are installed for alignment purposes only. Remove and discard fuel lines
after alignment is complete. Failure to follow this caution may result in damage to
equipment.
23. Install six sleeves (Figure 28, Item 4), and original high-pressure fuel lines (Figure 28, Item 3) on fuel injectors
(Figure 28, Item 1). Finger tighten lines.
24. Torque six torx bolts (Figure 28, Item 7) to 20 lb-ft (27 Nm).
25. Remove six high-pressure fuel lines (Figure 28, Item 3) from fuel injectors (Figure 28, Item 1). Discard
high-pressure fuel lines.
26. Torque 14 bolts (Figure 28, Item 5) in sequence shown (Figure 29) to 79 lb-in. (9 Nm).
Figure 28. Injector Alignment.
0114
Figure 29. Valve Mechanism Cover Base Torque Sequence.
0114
