TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2650-05 Primary Steering
4. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
Valve ECM Power Supply
continuity between harness con-
Remove jumper wire from harness
Output Current Below Nor-
nector U-C1 (WP 0009, Figure
connector U-C34 (WP 0009, Figure
mal - Continued
121) terminal 25 and terminal 55.
217) terminal 4 and terminal 6.
Resistance should be less than
Proceed to Test Step 3.
5.0 Ohms.
Resistance More Than 5.0 Ohms -
Replace front attachment wiring
harness (WP 0180).
Proceed to step 5.
5. Using the MSD (WP 0006), select 2650-03 Code Active - Repeat
Implement 120M and verify 2650- troubleshooting code from the
03 is not active.
beginning.
2650-03 Code Not Active -
Troubleshooting complete.
Test Step 3. Test Cab Lower Wiring
Harness.
1. Disconnect cab lower wiring har-
ness connector P-C41 (WP 0009,
Figure 68) from implement 1 ECM
J1 (WP 0009, Figure 69) (WP
0266).
2. Install a jumper wire between har-
ness connector P-C41 (WP 0009,
Figure 68) terminal 12 and termi-
nal 37.
0031-158