TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2650-05 Primary Steering
3. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
Valve ECM Power Supply
continuity between harness con-
Replace steering valve control module
Output Current Below Nor-
nector P-C50 (WP 0009, Figure
(WP 0242).
mal - Continued
120) terminal 25 and terminal 55.
Remove jumper wire from harness
Resistance should be less than
connector P-C41 (WP 0009, Figure
5.0 Ohms.
68) terminal 12 and terminal 37.
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement 1 ECM J1 (WP
0009, Figure 69) (WP 0266).
Connect front attachment wiring
harness connector U-C1 (WP 0009,
Figure 121) to cab lower wiring
harness connector P-C50 (WP 0009,
Figure 120).
Connect harness connector U-C34
(WP 0009, Figure 217) to steering
valve control module (WP 0242), and
install rear front frame cover (WP
0224).
Proceed to step 4.
Resistance More Than 5.0 Ohms -
Replace cab lower wiring harness
(WP 0266).
Connect front attachment wiring
harness connector U-C1 (WP 0009,
Figure 121) to cab lower wiring
harness connector P-C50 (WP 0009,
Figure 120).
Connect harness connector U-C34
(WP 0009, Figure 217) to steering
valve control module (WP 0242).
Proceed to step 4.
4. Using the MSD (WP 0006), select 2650-05 Code Active - Repeat
Implement 120M and verify 2650- troubleshooting code from the
05 is not active.
beginning.
2650-05 Code Not Active -
Troubleshooting complete.
0031-159