TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2650-03 Primary Steering
3. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
Valve ECM Power Supply
continuity between harness con-
Proceed to step 4.
Output Voltage Above Nor-
nector P-C50 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
mal - Continued
120) terminal 25 and terminal 55.
Replace cab lower wiring harness
Resistance should be less than
(WP 0266).
5.0 Ohms.
Connect front attachment wiring
harness connector U-C1 (WP 0009,
Figure 121) to cab lower wiring
harness connector P-C50 (WP 0009,
Figure 120).
Connect harness connector U-C34
(WP 0009, Figure 217) to steering
valve control module (WP 0242).
Proceed to step 6.
4. Remove jumper wire from har-
ness connector P-C41 (WP 0009,
Figure 68) terminal 12 and termi-
nal 37.
5. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C41 (WP 0009, Figure
Connect harness connector U-C34
68) terminal 12 and all other ter-
(WP 0009, Figure 217) to steering
minals on harness connector P-
valve control module (WP 0242), and
C41.
install rear front frame cover (WP
There should be no continuity.
0224).
Proceed to step 6.
No Continuity - Replace steering
valve control module (WP 0242).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement 1 ECM J1 (WP
0009, Figure 69) (WP 0266).
Connect front attachment wiring
harness connector U-C1 (WP 0009,
Figure 121) to cab lower wiring
harness connector P-C50 (WP 0009,
Figure 120).
Connect harness connector U-C34
(WP 0009, Figure 217) to steering
valve control module (WP 0242), and
install rear front frame cover (WP
0224).
Proceed to step 6.
0031-156