TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2954-14 Unknown Electronic 4. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
Implement Control Special
continuity between harness con-
Proceed to step 5.
Instruction - Continued
nector FA-C23 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
17) terminal 7 and machine
Verify rear frame ground is clean and
ground.
tight (WP 0009, Figure 133). If rear
Resistance should be less than
frame ground is OK, replace rear
5.0 Ohms.
chassis wiring harness (WP 0266).
Proceed to step 6.
5. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Proceed to Test Step 3.
nector FA-C23 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
17) terminal 14 and machine
Verify rear frame ground is clean and
ground.
tight (WP 0009, Figure 133). If rear
Resistance should be less than
frame ground is OK, replace rear
5.0 Ohms.
chassis wiring harness (WP 0266).
Proceed to step 6.
6. Using the MSD (WP 0006), select 2954-14 Code Active - Repeat
Implement 120M and verify 2954- troubleshooting code from the
14 is not active.
beginning.
2954-14 Code Not Active -
Troubleshooting complete.
Test Step 3. Test Cab Lower Har-
ness For An Open.
1. Connect harness connector FA-
C23 (WP 0009, Figure 17) to har-
ness connector P-C71 (WP 0009,
Figure 18) (WP 0188).
2. Disconnect cab lower wiring har-
ness connector P-C45 (WP 0009,
Figure 72) from implement 2 ECM
J1 (WP 0009, Figure 73).
3. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between cab lower wir-
Proceed to step 4.
ing harness connector P-C45
Resistance More Than 5.0 Ohms -
(WP 0009, Figure 72) terminal 13
Replace cab lower wiring harness
and machine ground.
(WP 0266).
Resistance should be less than
Connect cab lower wiring harness
5.0 Ohms.
connector P-C45 (WP 0009, Figure
72) to Implement 2 ECM J1 (WP
0009, Figure 73).
Proceed to step 11.
0031-163