TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-14 Machine Articula-
Test Step 4. Calibrate Sensor.
tion Angle Sensor #2 Special
1. Calibrate articulation angle posi-
Articulation Angle Position Sensor
Instruction - Continued
tion sensor. Refer to Calibration in
Cannot Be Calibrated - Perform
WP 0257.
calibration procedure again. If sensor
cannot be calibrated, replace
articulation angle position sensor 1
(right) (WP 0257).
Articulation Angle Position Sensor
Calibrated OK - Proceed to step 2.
2. Using MSD (WP 0006), select
2252-14 Code Active - Repeat
Implement 120M and verify 2252- troubleshooting from the beginning of
14 is active.
this diagnostic code.
2252-14 Code Not Active -
Troubleshooting complete.
2650-03 Primary Steering
System Response:
Valve ECM Power Supply
ECM will log a diagnostic code.
Output Voltage Above Nor-
mal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Verify 2650-03 code is
active.
1. Connect MSD (WP 0006), select
2650-03 Code Active - Proceed to
Implement 120M and check for
Test Step 2.
Active code 2650-03.
2650-03 Code Not Active -
Troubleshooting complete.
Test Step 2. Test Steering Valve
Control Module Power Supply Cir-
cuit In Front Attachment Wiring
Harness.
1. Disconnect harness connector U-
C34 (WP 0009, Figure 217) from
steering valve control module
(WP 0242).
0031-154
