TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2650-06 Primary Steering
4. Using the MSD (WP 0006), select 2650-06 Code Active - Repeat
Valve ECM Power Supply
Implement 120M and verify 2650- troubleshooting code from the
Output Current Above Nor-
06 is not active.
beginning.
mal - Continued
2650-06 Code Not Active -
Troubleshooting complete.
Test Step 3. Test Cab Lower Wiring
Harness.
1. Disconnect cab lower wiring har-
ness connector P-C41 (WP 0009,
Figure 68) from implement 1 ECM
J1 (WP 0009, Figure 69) (WP
0266).
2. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C41 (WP 0009, Figure
Connect harness connector U-C34
68) terminal 12 and all other ter-
(WP 0009, Figure 217) to steering
minals on harness connector P-
valve control module (WP 0242), and
C41 and to machine ground.
install rear front frame cover (WP
There should be no continuity.
0224).
Proceed to step 3.
No Continuity - Replace steering
valve control module (WP 0242).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement 1 ECM J1 (WP
0009, Figure 69) (WP 0266).
Connect front attachment wiring
harness connector U-C1 (WP 0009,
Figure 121) to cab lower wiring
harness connector P-C50 (WP 0009,
Figure 120).
Connect harness connector U-C34
(WP 0009, Figure 217) to steering
valve control module (WP 0242), and
install rear front frame cover (WP
0224).
Proceed to step 3.
3. Using the MSD (WP 0006), select 2650-06 Code Active - Repeat
Implement 120M and verify 2650- troubleshooting code from the
06 is not active.
beginning.
2650-06 Code Not Active -
Troubleshooting complete.
0031-161
