TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2203-03 Steering Valve Con-
trol Module Spool Position
valve control module (WP 0242).
Signal Lines Voltage Above
Connect harness connector U-C11
Normal - Continued
(WP 0009, Figure 256) to steering
valve pull up resistor (WP 0009,
Figure 257).
Connect front attachment wiring
harness connector U-C1 (WP 0009,
Figure 121) to cab lower wiring
harness connector P-C50 (WP 0009,
Figure 120) (WP 0180), and install
rear front frame cover (WP 0224).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement 1 ECM J1 (WP
0009, Figure 69) (WP 0266).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement 1 ECM J2 (WP
0009, Figure 71).
Proceed to step 14.
14. Using the MSD (WP 0006), select 2203-03 Code Active - Repeat
Implement 120M and verify 2203- troubleshooting code from the
03 is not active.
beginning.
2203-03 Code Not Active -
Troubleshooting complete.
0031-95