TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2203-03 Steering Valve Con-
Test Step 3. Test Steering Valve
trol Module Spool Position
Signal In Front Attachment Wiring
Signal Lines Voltage Above
Harness.
Normal - Continued
1. Install a jumper wire between har-
ness connector U-C34 (WP 0009,
Figure 217) terminal 2, and termi-
nal 4.
2. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Proceed to step 3.
nector U-C1 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
121) terminal 55 and terminal 62.
Replace front attachment wiring
Resistance should be less than
harness (WP 0180).
5.0 Ohms.
Proceed to step 6.
3. Remove jumper wire from har-
ness connector U-C34 (WP 0009,
Figure 217) terminal 2, and termi-
nal 4.
4. Using digital multimeter, test for
Continuity - Replace front
continuity between harness con-
attachment wiring harness (WP
nector U-C1 (WP 0009, Figure
0180).
121) terminal 55 and all other ter-
Proceed to step 6.
minals on harness connector U-
No Continuity - Proceed to step 5.
C1 and to machine ground.
There should be no continuity.
5. Using digital multimeter, test for
Continuity - Replace front
continuity between harness con-
attachment wiring harness (WP
nector U-C1 (WP 0009, Figure
0180).
121) terminal 62 and all other ter-
Proceed to step 6.
minals on harness connector U-
No Continuity - Proceed to Test Step
C1 and to machine ground.
4.
There should be no continuity.
6. Using the MSD (WP 0006), select 2203-03 Code Active - Repeat
Implement 120M and verify 2203- troubleshooting code from the
03 is not active.
beginning.
2203-03 Code Not Active -
Troubleshooting complete.
0031-91