TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2203-03 Steering Valve Con-
12. Using digital multimeter, test for
Continuity - Replace cab lower wiring
trol Module Spool Position
continuity between harness con-
harness (WP 0266).
Signal Lines Voltage Above
nector P-C41 (WP 0009, Figure
Connect harness connector U-C11
Normal - Continued
68) terminal 12 and all other ter-
(WP 0009, Figure 256) to steering
minals on harness connector P-
valve pull up resistor (WP 0009,
C41 and to machine ground.
Figure 257).
There should be no continuity.
Connect harness connector U-C34
(WP 0009, Figure 217) to steering
valve control module (WP 0242), and
install rear front frame cover (WP
0224).
Proceed to step 14.
No Continuity - Proceed to step 13.
13. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C41 (WP 0009, Figure
Connect harness connector U-C11
68) terminal 37 and all other ter-
(WP 0009, Figure 256) to steering
minals on harness connector P-
valve pull up resistor (WP 0009,
C41 and to machine ground.
Figure 257).
There should be no continuity.
Connect harness connector U-C34
(WP 0009, Figure 217) to steering
valve control module (WP 0242), and
install rear front frame cover (WP
0224).
Proceed to step 14.
0031-94