TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2203-03 Steering Valve Con-
Test Step 4. Test Cab Lower Wiring
trol Module Spool Position
Harness.
Signal Lines Voltage Above
Normal - Continued
1. Disconnect cab lower wiring har-
ness connector P-C41 (WP 0009,
Figure 68) from implement 1 ECM
J1 (WP 0009, Figure 69) (WP
0266).
2. Install a jumper wire between har-
ness connector P-C41 (WP 0009,
Figure 68) terminal 12 and termi-
nal 37.
3. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Proceed to step 4.
nector P-C50 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
120) terminal 25 and terminal 55.
Replace cab lower wiring harness
Resistance should be less than
(WP 0266).
5.0 Ohms.
Connect harness connector U-C11
(WP 0009, Figure 256) to steering
valve pull up resistor (WP 0009,
Figure 257).
Connect harness connector U-C34
(WP 0009, Figure 217) to steering
valve control module (WP 0242).
Proceed to step 14.
4. Remove jumper wire from har-
ness connector P-C41 (WP 0009,
Figure 68) terminal 12 and termi-
nal 37.
5. Install a jumper wire between har-
ness connector P-C41 (WP 0009,
Figure 68) terminal 37 and termi-
nal 40.
0031-92