TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2203-04 Steering Valve Con-
5. Using the MSD (WP 0006), select 2203-04 Code Active - Repeat
trol Module Spool Position
Implement 120M and verify 2203- troubleshooting code from the
Signal Lines Voltage Below
04 is not active.
beginning.
Normal - Continued
2203-04 Code Not Active -
Troubleshooting complete.
Test Step 3. Test Cab Lower Wiring
Harness.
1. Disconnect cab lower wiring har-
ness connector P-C41 (WP 0009,
Figure 68) from implement 1 ECM
J1 (WP 0009, Figure 69) (WP
0266).
2. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C41 (WP 0009, Figure
Connect harness connector U-C34
68) terminal 37 and all other ter-
(WP 0009, Figure 217) to steering
minals on harness connector P-
valve control module (WP 0242), and
C41 and to machine ground.
install rear front frame cover (WP
There should be no continuity.
0224).
Proceed to step 3.
No Continuity - Replace steering
valve control module (WP 0242).
Connect front attachment wiring
harness connector U-C1 (WP 0009,
Figure 121) to cab lower wiring
harness connector P-C50 (WP 0009,
Figure 120) (WP 0180), and install
rear front frame cover (WP 0224).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement 1 ECM J1 (WP
0009, Figure 69) (WP 0266).
Proceed to step 3.
3. Using the MSD (WP 0006), select 2203-04 Code Active - Repeat
Implement 120M and verify 2203- troubleshooting code from the
04 is not active.
beginning.
2203-04 Code Not Active -
Troubleshooting complete.
0031-97