TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2210-03 Auxiliary Lever #7
System Response:
Position Sensor Voltage
ECM will log a diagnostic code.
Above Normal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Verify 2210-03 code is
active.
1. Connect MSD (WP 0006), select
2210-03 Code Active - Proceed to
Implement 120M and check for
Test Step 2.
Active code 2210-03.
2210-03 Code Not Active -
Troubleshooting complete.
Test Step 2. Test Scarifier Lever
Voltage Supply Circuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect cab lower harness
connector P-C33 (WP 0009, Fig-
ure 209) from scarifier lever (WP
0009, Figure 210) (WP 0275).
3. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
4. Using digital multimeter, test for
Voltage Between 7 and 11 Volts -
voltage between harness connec-
proceed to Test Step 3.
tor P-C33 (WP 0009, Figure 209)
Voltage Less Than 7 Volts - Proceed
terminal 1 and machine ground.
to step 5.
Voltage should be between 7 and 11
volts.
5. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
0031-98
