TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2202-14 Steering Valve Con-
trol Module Bad Device or
continuity between harness con-
harness (WP 0266).
Component - Continued
nector P-C39 (WP 0009, Figure
Connect harness connector U-C11
70) terminal 20 and all other ter-
(WP 0009, Figure 256) to steering
minals on harness connector P-
valve pull up resistor (WP 0009,
C39 and to machine ground.
Figure 257).
There should be no continuity.
Connect harness connector U-C34
(WP 0009, Figure 217) to steering
valve control module (WP 0242), and
install rear front frame cover (WP
0224).
Proceed to step 17.
valve control module (WP 0242).
Connect harness connector U-C11
(WP 0009, Figure 256) to steering
valve pull up resistor (WP 0009,
Figure 257).
Connect front attachment wiring
harness connector U-C1 (WP 0009,
Figure 121) to cab lower wiring
harness connector P-C50 (WP 0009,
Figure 120) (WP 0180), and install
rear front frame cover (WP 0224).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement 1 ECM J1 (WP
0009, Figure 69) (WP 0266).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement 1 ECM J2 (WP
0009, Figure 71).
Proceed to step 17.
17. Using the MSD (WP 0006), select 2202-14 Code Active - Repeat
Implement 120M and verify 2202- troubleshooting code from the
14 is not active.
beginning.
2202-14 Code Not Active -
Troubleshooting complete.
0031-88