TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2202-14 Steering Valve Con-
Resistance 5.0 Ohms or Less -
trol Module Bad Device or
continuity between harness con-
Replace cab lower wiring harness
Component - Continued
nector P-C41 (WP 0009, Figure
(WP 0266).
68) terminal 12 and all other ter-
Connect harness connector U-C11
minals on harness connector P-
(WP 0009, Figure 256) to steering
C41 and to machine ground.
valve pull up resistor (WP 0009,
Figure 257).
5.0 Ohms.
Connect harness connector U-C34
(WP 0009, Figure 217) to steering
valve control module (WP 0242), and
install rear front frame cover (WP
0224).
Proceed to step 17.
Proceed to step 13.
continuity between harness con-
harness (WP 0266).
nector P-C41 (WP 0009, Figure
Connect harness connector U-C11
68) terminal 37 and all other ter-
(WP 0009, Figure 256) to steering
minals on harness connector P-
valve pull up resistor (WP 0009,
C41 and to machine ground.
Figure 257).
There should be no continuity.
Connect harness connector U-C34
(WP 0009, Figure 217) to steering
valve control module (WP 0242), and
install rear front frame cover (WP
0224).
Proceed to step 17.
No Continuity - Proceed to step 14.
continuity between harness con-
harness (WP 0266).
nector P-C41 (WP 0009, Figure
Connect harness connector U-C11
68) terminal 40 and all other ter-
(WP 0009, Figure 256) to steering
minals on harness connector P-
valve pull up resistor (WP 0009,
C41 and to machine ground.
Figure 257).
There should be no continuity.
Connect harness connector U-C34
(WP 0009, Figure 217) to steering
valve control module (WP 0242), and
install rear front frame cover (WP
0224).
Proceed to step 17.
No Continuity - Proceed to step 15.
0031-86