TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2113-03 Operator In-Seat
2. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
Switch Voltage Above Nor-
resistance between cab lower wir-
Rear chassis wiring harness is open,
mal - Continued
ing harness connector P-C69
replace rear chassis wiring harness
(WP 0009, Figure 46) terminal 67
(WP 0188).
and terminal 43.
Remove jumper wire from cab lower
Resistance should be less than
wiring harness connector P-C2 (WP
5.0 ohms.
0009, Figure 184) terminal A and
terminal B.
Connect the cab lower wiring harness
connector P-C2 (WP 0009, Figure
184) to operator in-seat switch (WP
0009, Figure 185) (WP 0284).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Cab lower wiring harness is open,
replace cab lower wiring harness (WP
0266).
Connect the rear chassis wiring
harness connector FA-C20 (WP 0009,
Figure 113) to transmission ECM J-1
(WP 0009, Figure 112).
Proceed to step 3.
3. Using the MSD (WP 0006), select
2113-03 Code Active - Repeat
Implement 120M and verify 2113-
troubleshooting code from the
03 is not active.
beginning.
2113-03 Code Not Active -
Troubleshooting complete.
Test Step 4. Test for Open Rear
Chassis Wiring Harness.
1. Remove jumper wire from cab
lower wiring harness connector P-
C2 (WP 0009, Figure 184) termi-
nal A and terminal B.
2. Connect jumper wire between cab
lower wiring harness connector P-
C2 (WP 0009, Figure 184) termi-
nal A and terminal C.
3. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between rear chassis
Proceed to Test Step 6.
wiring harness connector FA-C20
Resistance 5.0 Ohms or Greater -
(WP 0009, Figure 113) terminal
Proceed to Test Step 5.
64 and terminal 70.
Resistance should be less than
5.0 ohms.
0027-131
