TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0681-05 Parking Brake Sole-
System Response:
noid Current Below Normal
ECM will log a diagnostic code.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 0681-05
is Active.
1. Connect MSD (WP 0006). Select
0681-05 Code Active - Proceed to
Trans/Chassis 120M and verify
Test Step 2.
0681-05 is active.
0681-05 Code Not Active - Trouble-
shooting complete.
Test Step 2. Test Solenoid Control
and Return Circuits.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect harness connector T-
C11 (WP 0009, Figure 139) from
parking brake solenoid (WP 0009,
Figure 140) (WP 0156).
3. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
4. Install a jumper wire between har-
ness connector T-C11 (WP 0009,
Figure 139) terminal 1 and termi-
nal 2.