TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0681-05 Parking Brake Sole-
5. Using MSD (WP 0006). Select
0681-05 Code Remains Active -
noid Current Below Normal -
Trans/Chassis 120M and verify
Remove jumper wire from harness
Continued
0681-06 is active.
connector T-C11 (WP 0009, Figure
139) terminal 1 and terminal 2.
Proceed to Test Step 3.
0681-06 Code Becomes Active -
Replace transmission ECM (WP
0137).
Connect harness connector T-C11
(WP 0009, Figure 139) to parking
brake solenoid (WP 0009, Figure 140)
(WP 0156).
Proceed to step 6.
6. Using MSD (WP 0006), verify
0681-05 Code Remains Active -
0681-05 is not active.
Repeat troubleshooting from the
beginning of this diagnostic code.
0681-05 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test Solenoid Control
and Return Circuits for Continuity.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect rear chassis harness
connector FA-C28 (WP 0009, Fig-
ure 129) from transmission wiring
harness connector T-C1 (WP
0009, Figure 130).
3. Disconnect harness connector
FA-C21 (WP 0009, Figure 124)
from transmission ECM J2 (WP
0009, Figure 112) (WP 0137).
4. Install a jumper wire between har-
ness connector FA-C28 (WP
0009, Figure 129) terminal 5 and
terminal 6.
0017-117