TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-03 Machine Articula-
6. Install a jumper wire between har-
tion Angle Sensor Voltage
ness connector P-C41 (WP 0009,
Above Normal - Continued
Figure 68) terminal 44 and termi-
nal 45.
7. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
continuity between harness con-
Proceed to step 8.
nector FA-C23 (WP 0009, Figure
Resistance 5.0 Ohms or More -
17) terminal 4 and terminal 19.
Replace cab lower wiring harness
Resistance should be less than
(WP 0266).
5.0 ohms.
Connect secondary steering harness
connector AT-C3 (WP 0009, Figure
144) to left articulation angle position
sensor (WP 0009, Figure 145) (WP
0257).
Proceed to step 10.
8. Disconnect rear chassis wiring
harness connector FA-C5 (WP
0009, Figure 111) from second-
ary steering wiring harness AT-C1
(WP 0009, Figure 110) (WP
0186).
9. Using digital multimeter, test for
0615-03 Machine Articulation Angle
continuity between rear chassis
Sensor Voltage Above Normal -
wiring harness connector FA-C23
Continued
(WP 0009, Figure 17) terminal 4
and rear chassis wiring harness
connector FA-C5 (WP 0009, Fig-
ure 111) terminal 6.
Resistance should be less than
5.0 ohms.
0615-03 Code Active - Repeat trou-
10. Connect MSD (WP 0006). Select
bleshooting from the beginning of this
Trans/Chassis 120M and verify
diagnostic code.
0615-03 is active.
0615-03 Code Not Active - Trouble-
shooting complete.
Test Step 5. Check Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect secondary steering
harness connector AT-C3 (WP
0009, Figure 144) from left articu-
lation angle position sensor (WP
0009, Figure 145) (WP 0257).
0017-47