TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0585-02 Transmission Out-
12. Using MSD (WP 0006), verify
0585-02 Code Remains Active -
put Speed Sensor #1 Data
0585-02 is not active.
Repeat troubleshooting from the
Erratic, Intermittent or Incor-
beginning of this diagnostic code.
rect - Continued
0585-02 Code Not Active - Trouble-
shooting complete.
0588-09 Monitoring System
System Response:
Display Abnormal Update
ECM will log a diagnostic code.
Rate
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 0588-09
is Active.
1. Connect MSD (WP 0006). Select
0588-09 Code Active - Proceed to
Trans/Chassis 120M and verify
Test 2.
0588-09 is active.
0588-09 Code Not Active - Trouble-
shooting complete.
Test Step 2. Test Voltage Supply
and Ground Circuits.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect cab lower wiring har-
ness connector P-C93 (WP 0009,
Figure 163) from messenger (WP
0009, Figure 164) (WP 0272).
3. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
4. Using digital multimeter, test for
Voltage 18 to 26 Volts - Proceed to
voltage between harness connec-
step 5.
tor P-C93 (WP 0009, Figure 163)
Voltage Less Than 18 Volts -
terminal 1 and machine ground.
Replace cab lower wiring harness
Voltage should be 18 to 26 volts.
(WP 0266).
Proceed to step 8.