TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0573-04 Inching Pedal Posi-
7. Using a digital multimeter, test for
No Continuity - Proceed to step 8.
tion Sensor Voltage Below
continuity between harness con-
Continuity - Replace rear chassis
Normal - Continued
nector FA-C21 (WP 0009, Figure
wiring harness (WP 0188).
124) terminal 43 and all other ter-
Connect harness connector P-C40
minals on harness connector FA-
(WP 0009, Figure 114) from inching
C21 and to machine ground.
pedal position sensor (WP 0009, Fig-
There should be no continuity.
ure 115) (WP 0289).
Proceed to step 9.
8. Using digital multimeter, test for
No Continuity - Replace inching
continuity between harness con-
pedal position sensor (WP 0289).
nector FA-C22 (WP 0009, Figure
Connect harness connector FA-C22
47) terminal 55 and all other ter-
(WP 0009, Figure 47) to harness con-
minals on harness connector FA-
nector P-C69 (WP 0009, Figure 46)
C22 and to machine ground.
(WP 0188).
There should be no continuity.
Connect harness connector FA-C21
(WP 0009, Figure 124) to transmis-
sion ECM J2 (WP 0009, Figure 112).
Proceed to step 9.
Continuity - Replace cab lower wiring
harness (WP 0266).
Connect harness connector FA-C21
(WP 0009, Figure 124) to transmis-
sion ECM J2 (WP 0009, Figure 112).
Proceed to step 9.
9. Using MSD (WP 0006), verify
0573-03 Code Remains Active -
0573-03 is not active.
Repeat troubleshooting from the
beginning of this diagnostic code.
0573-03 Code Not Active - Trouble-
shooting complete.
0017-6