TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0590-09 Engine Control
6. Using digital multimeter, test for
Voltage 18 to 26 Volts- Proceed to
Module Abnormal Update
Voltage Between harness con-
step 7.
Rate - Continued
nector FA-C17 (WP 0009, Figure
Voltage Less Than 18 Volts - Pro-
14) terminal 15 and machine
ceed to Test Step 3.
ground.
Voltage should be 18 to 26 volts.
7. Using digital multimeter, test for
Voltage 18 to 26 Volts - Proceed to
Voltage Between harness con-
step 8.
nector FA-C17 (WP 0009, Figure
Voltage Less Than 18 Volts - Pro-
14) terminal 16 and machine
ceed to Test Step 3.
ground.
Voltage should be 18 to 26 volts.
N OT E
Harness connector is located behind cab bulkhead cover on right rear
of cab.
8. Remove rear bulkhead cover
plate (WP 0266).
9. Disconnect harness connector
FA-C22 (WP 0009, Figure 47)
from harness connector P-C69
(WP 0009, Figure 46).
10. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
11. Using digital multimeter, test for
No Continuity or Resistance More
continuity between harness con-
Than 5.0 Ohms - Verify rear frame
nector FA-C17 (WP 0009, Figure
ground (WP 0009, Figure 133) is
14) terminal 1 and machine
clean and tight. If rear frame ground is
ground.
OK, replace rear chassis wiring har-
Resistance should be less than
ness (WP 0188).
5.0 ohms.
Connect harness connector FA-C17
(WP 0009, Figure 14) to engine ECM
J1 (WP 0067).
Proceed to step 15.
Resistance 5.0 Ohms or Less - Pro-
ceed to step 12.
0017-15