TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0573-03 Inching Pedal Posi-
5. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
tion Sensor Voltage Above
continuity between harness con-
Replace inching pedal position sensor
Normal - Continued
nector FA-C21 (WP 0009, Figure
(WP 0289).
124) terminal 43 and harness
Connect harness connector FA-C21
connector FA-C20 (WP 0009, Fig-
(WP 0009, Figure 124) to transmis-
ure 113) terminal 44.
sion ECM J2 (WP 0009, Figure 112).
Resistance should be less than
Connect harness connector FA-C20
5.0 ohms.
(WP 0009, Figure 113) from transmis-
sion ECM J1 (WP 0009, Figure 112).
Proceed to step 10.
Resistance More Than 5.0 Ohms -
Proceed to step 6.
6. Remove rear bulkhead cover
plate (WP 0266) from rear of cab.
7. Disconnect harness connector
FA-C22 (WP 0009, Figure 47)
from harness connector P-C69
(WP 0009, Figure 46) (WP 0188).
8. Using a digital multimeter, test for
No Continuity - Proceed to step 9.
continuity between harness con-
Continuity - Replace rear chassis
nector FA-C21 (WP 0009, Figure
wiring harness (WP 0188).
124) terminal 43 and all other ter-
Connect harness connector P-C40
minals on harness connector FA-
(WP 0009, Figure 114) from inching
C21.
pedal position sensor (WP 0009, Fig-
There should be no continuity.
ure 115) (WP 0289).
Proceed to step 10.
9. Using digital multimeter, test for
No Continuity - Replace transmis-
continuity between harness con-
sion ECM (WP 0137).
nector P-C69 (WP 0009, Figure
Connect harness connector P-C40
46) terminal 55 and all other ter-
(WP 0009, Figure 114) to inching
minals on harness connector FA-
pedal position sensor (WP 0009, Fig-
C22.
ure 115) (WP 0289).
There should be no continuity.
Proceed to step 10.
Continuity - Replace cab lower wiring
harness (WP 0266).
Connect harness connector FA-C21
(WP 0009, Figure 124) to transmis-
sion ECM J2 (WP 0009, Figure 112).
Connect harness connector FA-C20
(WP 0009, Figure 113) to transmis-
sion ECM J1 (WP 0009, Figure 112).
Proceed to step 10.
0017-4