TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
7. Disconnect harness connector
0573-03 Inching Pedal Posi-
FA-C23 (WP 0009, Figure 17)
tion Sensor Voltage Above
from harness connector P-C71
Normal - Continued
(WP 0009, Figure 18) (WP 0188).
8. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
9. Using digital multimeter, test for
Voltage Between 7.6 and 8.4 Volts -
Voltage Between harness con-
Replace cab lower wiring harness
nector FA-C23 (WP 0009, Figure
(WP 0266).
17) terminal 44 and machine
Proceed to step 10.
ground.
Voltage Less than 7.6 Volts -
Voltage should be between 7.6 and
Replace rear chassis wiring harness
8.4 volts.
(WP 0188).
Connect harness connector P-C40
(WP 0009, Figure 114) to inching
pedal position sensor (WP 0009, Fig-
ure 115) (WP 0289), and install instru-
ment panel cover (WP 0289).
Proceed to step 10.
10. Using MSD (WP 0006), verify
0573-03 Code Remains Active -
0573-03 is not active.
Repeat troubleshooting from the
beginning of this diagnostic code.
0573-03 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test Sensor Signal Cir-
cuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect harness connector
FA-C21 (WP 0009, Figure 124)
from transmission ECM J2 (WP
0009, Figure 112).
3. Disconnect harness connector
FA-C20 (WP 0009, Figure 113)
from transmission ECM J1 (WP
0009, Figure 112).
4. Install a jumper wire between
inching pedal position sensor har-
ness connector P-C40 (WP 0009,
Figure 114) terminal A and termi-
nal C.
0017-3