TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2194-03 All-Wheel Drive
4. Using a digital multimeter, test for
No Continuity - Proceed to Test Step
(AWD) Control Dial Position
continuity between P-C37 termi-
18.
Sensor Voltage Above Nor-
nal 26 (WP 0009, Figure 55) and
Continuity - Replace cab lower wiring
mal - Continued
all circuits in P-C35 (WP 0009,
harness (WP 0266).
Figure 53). There should be no
Connect R-C12 (WP 0009, Figure 88)
continuity.
on AWD control dial position sensor
connector (WP 0009, Figure 89) WP
0271).
Proceed to step 5.
5. Using the MSD (WP 0006), select
2194-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2194-03 is not active.
2194-03 Code Not Active - Trouble-
shooting complete.
Test Step 18. Test G858-OR Signal
Circuit for Short to Other Voltage
Source in Cab Lower Wiring Har-
ness.
1. Turn battery disconnect switch
and ignition switch to the ON posi-
tion.
2. Using a digital multimeter, mea-
Voltage Greater Than 0.3 Volts -
sure voltage between P-C37 ter-
Replace cab lower wiring harness
minal 26 (WP 0009, Figure 55)
(WP 0266).
and ground.
Connect R-C12 (WP 0009, Figure 88)
on AWD control dial position sensor
connector (WP 0009, Figure 89) (WP
0271).
Proceed to step 3.
Voltage 0.3 Volts or Lower - Replace
AWD ECM (WP 0270).
Connect P-C3 (WP 0009, Figure 34)
on R-C1 (WP 0009, Figure 33) (WP
0266).
Connect P-C42 (WP 0009, Figure 90)
on R-C3 (WP 0009, Figure 91) (WP
0266).
Connect R-C12 (WP 0009, Figure 88)
on AWD control dial position sensor
connector (WP 0009, Figure 89) (WP
0271).
Proceed to step 3.
3. Using the MSD (WP 0006), select
2194-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2194-03 is not active.
2194-03 Code Not Active - Trouble-
shooting complete.
0013-115