TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2194-03 All-Wheel Drive
4. Using a digital multimeter, test for
No Continuity - Proceed to step 5.
(AWD) Control Dial Position
continuity between R-C1 terminal
Continuity on One or More Test
Sensor Voltage Above Nor-
53 and all other circuits in R-C1
Points - Replace cab upper wiring
mal - Continued
(WP 0009, Figure 33). There
harness (WP 0265).
should be no continuity.
Proceed to step 6.
5. Using a digital multimeter, test for
No Continuity - Proceed to Test Step
continuity between R-C1 terminal
17.
53 (WP 0009, Figure 33) and all
Continuity on One or More Test
circuits in R-C3 WP 0009, Figure
Points - Replace cab upper wiring
91). There should be no continu-
harness (WP 0265).
ity.
Proceed to step 6.
6. Using the MSD (WP 0006), select
2194-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2194-03 is not active.
2194-03 Code Not Active - Trouble-
shooting complete.
Test Step 17. Test G858-OR Signal
Circuit for Short to Other Circuits in
Cab Lower Wiring Harness.
1. Disconnect cab lower wiring P-
C35 harness connector (WP
0009, Figure 53) from AWD ECM
J1 (WP 0009, Figure 54) (WP
0270).
2. Disconnect cab lower wiring P-
C37 harness connector (WP
0009, Figure 55) from AWD ECM
J2 (WP 0009, Figure 56) (WP
0270).
3. Using a digital multimeter, test for
No Continuity - Proceed to step 4.
continuity between P-C37 termi-
Continuity - Replace cab lower wiring
nal 26 and all other circuits in P-
harness (WP 0266).
C37 (WP 0009, Figure 55). There
Connect R-C12 (WP 0009, Figure 88)
should be no continuity.
on AWD control dial position sensor
connector (WP 0009, Figure 89) (WP
0271).
Proceed to step 5.
0013-114