TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2194-03 All-Wheel Drive
2. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
Replace AWD ECM (WP 0270).
(AWD) Control Dial Position
sure resistance of circuit G858-
Sensor Voltage Above Nor-
OR between P-C3 terminal 53
Connect P-C3 (WP 0009, Figure 34)
mal - Continued
(WP 0009, Figure 34) and P-C37
on R-C1 (WP 0009, Figure 33) (WP
terminal 26 (WP 0009, Figure 55).
0266).
Connect P-C42 (WP 0009, Figure 90)
on R-C3 (WP 0009, Figure 91) (WP
0266).
Connect R-C12 (WP 0009, Figure 88)
on AWD control dial position sensor
connector (WP 0009, Figure 89) (WP
0271).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Replace cab lower wiring harness
(WP 0266).
Connect R-C12 (WP 0009, Figure 88)
on AWD control dial position sensor
connector (WP 0009, Figure 89) (WP
0271).
Proceed to step 3.
3. Using the MSD (WP 0006), select
2194-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2194-03 is not active.
2194-03 Code Not Active - Trouble-
shooting complete.
Test Step 16. Test G858-OR Signal
Circuit for Short to Other Circuits in
Cab Upper Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect cab lower wiring P-
C42 harness connector (WP
0009, Figure 90) from cab upper
wiring R-C3 harness connector
(WP 0009, Figure 91) (WP 0266).
3. Disconnect cab lower wiring P-C3
harness connector (WP 0009,
Figure 34) from cab upper wiring
R-C1 harness connector (WP
0009, Figure 33) (WP 0266).
0013-113