TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2194-03 All-Wheel Drive
Test Step 19. Test A201-BK
(AWD) Control Dial Position
Unswitched Battery (-) Circuit in
Sensor Voltage Above Nor-
Cab Upper Wiring Harness for High
mal - Continued
Resistance or Open.
1. Disconnect cab lower wiring P-
C42 harness connector (WP
0009, Figure 90) from cab upper
wiring R-C3 harness connector
(WP 0009, Figure 91) (WP 0266).
2. Disconnect cab lower wiring P-C3
harness connector (WP 0009,
Figure 34) from cab upper wiring
R-C1 harness connector (WP
0009, Figure 33) (WP 0266).
3. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
sure resistance between R-C1
Proceed to Test Step 20.
terminal 39 (WP 0009, Figure 33)
Resistance 5.0 Ohms or Greater -
and R-C12 terminal B (WP 0009,
Replace cab upper wiring harness
Figure 88).
(WP 0265).
Proceed to step 4.
4. Using the MSD (WP 0006), select
2194-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2194-03 is not active.
2194-03 Code Not Active - Trouble-
shooting complete.
Test Step 20. Inspect Ground
Points of Cab Lower Wiring Har-
ness.
1. Inspect ground points of cab
Ground Point or Ring Terminal
lower wiring harness (WP 0009,
Dirty or Corroded - Clean as neces-
sary.
Figure 65) for dirt, corrosion, and
damage.
Connect P-C3 (WP 0009, Figure 34)
on R-C1 (WP 0009, Figure 33) (WP
0266).
Connect P-C42 (WP 0009, Figure 90)
on R-C3 (WP 0009, Figure 91) (WP
0266).
Connect R-C12 (WP 0009, Figure 88)
on AWD control dial position sensor
connector (WP 0009, Figure 89) (WP
0271).
Proceed to step 2.
0013-116