TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2194-03 All-Wheel Drive
Test Step 13. Test 156-YL Power
(AWD) Control Dial Position
Circuit for Short to Other Circuits in
Sensor Voltage Above Nor-
Cab Lower Wiring Harness.
mal - Continued
1. Remove rear front frame cover
from machine (WP 0224).
2. Disconnect clutch drive solenoid
AF-C3 harness connector (WP
0009, Figure 51) from cab lower
wiring P-C34 harness connector
(WP 0009, Figure 52) (WP 0200).
3. Using a digital multimeter, test for
No Continuity - Proceed to step 4.
continuity between P-C3 terminal
Continuity - Replace cab lower wiring
10 and all other circuits in P-C3
harness (WP 0266).
(WP 0009, Figure 34). There
Connect right AWD clutch pressure
should be no continuity.
sensor (WP 0009, Figure 94) on AF-
C17 (WP 0009, Figure 95).
Connect left AWD clutch pressure
sensor (WP 0009, Figure 92) on AF-
C16 (WP 0009, Figure 93).
Install nose front frame cover on
machine (WP 0224).
Connect R-C12 (WP 0009, Figure 88)
on AWD control dial position sensor
connector (WP 0009, Figure 89) (WP
0271).
Install new fuse F7 on fuse box.
Install cover on fuse box.
Proceed to step 6.
4. Using a digital multimeter, test for
No Continuity - Proceed to step 5.
continuity between P-C3 terminal
Continuity - Replace cab lower wiring
10 (WP 0009, Figure 34) and all
harness (WP 0266).
circuits in P-C42 (WP 0009, Fig-
Connect right AWD clutch pressure
ure 90). There should be no conti-
sensor (WP 0009, Figure 94) on AF-
nuity.
C17 (WP 0009, Figure 95).
Connect left AWD clutch pressure
sensor (WP 0009, Figure 92) on AF-
C16 (WP 0009, Figure 93).
Install nose front frame cover on
machine (WP 0224).
Connect R-C12 (WP 0009, Figure 88)
on AWD control dial position sensor
connector (WP 0009, Figure 89) (WP
0271).
0013-110