TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2194-03 All-Wheel Drive
Test Step 7. Test for Open Fuse F7.
(AWD) Control Dial Position
Using a digital multimeter, measure
Voltage Within 18-26 Volts - Proceed
Sensor Voltage Above Nor-
for 18-26 Volts DC between fuse F7
to Test Step 8.
mal - Continued
top terminal (Figure 2) and ground.
Voltage Not Within 18-26 Volts -
Turn ignition switch and battery dis-
connect switch to the OFF position.
Remove fuse F7 from fuse box and
discard fuse. Proceed to Test Step 9.
Figure 2. Fuse F7 Top Terminal.
0013
Test Step 8. Test for Cab Upper Wir-
ing Harness for an Open.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect cab lower wiring P-
C42 harness connector (WP
0009, Figure 90) from cab upper
wiring R-C3 harness connector
(WP 0009, Figure 91) (WP 0266).
3. Disconnect cab lower wiring P-C3
harness connector (WP 0009,
Figure 34) from cab upper wiring
R-C1 harness connector (WP
0009, Figure 33) (WP 0266).