TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2194-03 All-Wheel Drive
4. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
(AWD) Control Dial Position
sure resistance between R-C1
Replace cab lower wiring harness
Sensor Voltage Above Nor-
terminal 10 (WP 0009, Figure 33)
(WP 0266).
mal - Continued
and R-C12 terminal A (WP 0009,
Connect R-C12 (WP 0009, Figure 88)
Figure 88).
on AWD control dial position sensor
connector (WP 0009, Figure 89) (WP
0271).
Install cover on fuse box.
Proceed to step 5.
Resistance 5.0 Ohms or Greater -
Replace cab upper wiring harness
(WP 0265).
Install cover on fuse box.
Proceed to step 5.
5. Using the MSD (WP 0006), select
2194-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2194-03 is not active.
2194-03 Code Not Active - Trouble-
shooting complete.
Test Step 9. Test 156-YL Power Cir-
cuit for short to other circuits in
Cab Upper Wiring Harness.
1. Disconnect cab lower wiring P-
C42 harness connector (WP
0009, Figure 90) from cab upper
wiring R-C3 harness connector
(WP 0009, Figure 91) (WP 0266).
2. Disconnect cab lower wiring P-C3
harness connector (WP 0009,
Figure 34) from cab upper wiring
R-C1 harness connector (WP
0009, Figure 33) (WP 0266).
3. Using a digital multimeter, test for
No Continuity - Proceed to step 4.
continuity between R-C1 terminal
Continuity - Replace cab upper wir-
10 and all other circuits in R-C1
ing harness (WP 0265).
(WP 0009, Figure 33). There
Install new fuse F7 on fuse box.
should be no continuity.
Install cover on fuse box.
Proceed to step 6.
0013-104