TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0517-04 All-Wheel Drive
Test Step 9. Test 823-GN Off Mode
(AWD) Switch Voltage Below
Circuit for Short to Implement 2 Cir-
Normal - Continued
cuits in Cab Lower Wiring Harness.
1. Using a digital multimeter, test for
No Continuity - Proceed to step 2.
continuity between P-C35 termi-
Continuity - Replace cab lower wiring
nal 34 (WP 0009, Figure 53) and
harness (WP 0266).
all circuits in P-C45 (WP 0009,
Connect R-C16 (WP 0009, Figure 66)
Figure 72). There should be no
on AWD mode switch connector (WP
continuity.
0009, Figure 67) (WP 0275).
Proceed to step 3.
2. Using a digital multimeter, test for
No Continuity -Proceed to Test Step
continuity between P-C35 termi-
10.
nal 34 (WP 0009, Figure 53) and
Continuity - Replace cab lower wiring
all circuits in P-C27 (WP 0009,
harness (WP 0266).
Figure 74). There should be no
Connect R-C16 (WP 0009, Figure 66)
continuity.
on AWD mode switch connector (WP
0009, Figure 67) (WP 0275).
Proceed to step 3.
3. Using the MSD (WP 0006), select
0517-04 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0517-04 is not active.
0517-04 Code Not Active - Trouble-
shooting complete.
Test Step 10. Test 718-BU Manual
Mode Circuit for Short to Imple-
ment 1 Circuits in Cab Lower Wir-
ing Harness.
1. Using a digital multimeter, test for
No Continuity - Proceed to step 2.
continuity between P-C35 termi-
Continuity - Replace cab lower wiring
nal 40 (WP 0009, Figure 53) and
harness (WP 0266).
all circuits in P-C41 (WP 0009,
Connect R-C16 (WP 0009, Figure 66)
Figure 68). There should be no
on AWD mode switch connector (WP
continuity.
0009, Figure 67) (WP 0275).
Proceed to step 3.
2. Using a digital multimeter, test for
No Continuity - Proceed to Test Step
continuity between P-C35 termi-
11.
nal 40 (WP 0009, Figure 53) and
Continuity - Replace cab lower wiring
all circuits in P-C39 (WP 0009,
harness (WP 0266).
Figure 70). There should be no
Connect R-C16 (WP 0009, Figure 66)
continuity.
on AWD mode switch connector (WP
0009, Figure 67) (WP 0275).
Proceed to step 3.
0013-33