TM 5-3805-261-34
ENGINE MAINTENANCE. (cont)
3-4.
Engine. (Sheet 4 of 13)
REMOVAL (cont)
10.
Remove bolt (14), washer (15) and
clip (16, Figure 3-5).
NOTE
All hose and tube assemblies
must be tagged before
disconnecting to aid in
installation. Cap all hose
and tube ends to prevent
contamination.
11.
Disconnect hose assembly (17)
from fuel injection pump.
12.
Disconnect hose assembly (34)
from fuel transfer pump.
13.
Remove and discard cotter pin
(18) from pin (19).
14.
Remove pin (19).
15.
Separate linkage assembly (74)
from governor control assembly
(20) lever.
16.
Support governor control assembly
(20).
17.
Remove three bolts (21), washers
(22) and clips (23 and 24).
18.
Position governor control
assembly (20) in engine
compartment.
Go to Sheet 5
3-20
Figure 3-5.