TM 5-3805-261-34
TRANSMISSION MAINTENANCE.
14-2.
Transmission Assembly. (Sheet 19 of 20)
ASSEMBLY
74.
Install 3/8-16NC x 4 bolt in
shaft (34, Figure 14-32).
75.
Install dial test indicator.
76.
Move gear (34) up and down from
bottom of transmission housing
and check end clearance. End
clearance must be .002 to .006
inch. Add or remove shim(s) from
shim pack (22) to get correct end
clearance.
77.
Remove dial test indicator.
78.
Remove 3/8-16NC x 4 bolt.
79.
Install guide (18) on gear (34,
Figure 14-33).
80.
Install two lifting eyes (54),
lockwashers (53) and bolts (52).
81.
Install elbow (51) and breather
(50).
Go to Sheet 20
Figure 14-32.
Figure 14-33.
14-21