TRANSMISSION MAINTENANCE. (cont) - TM-5-3805-261-34

TRANSMISSION MAINTENANCE. (cont) - TM-5-3805-261-34_912

TRANSMISSION MAINTENANCE. (cont) - TM-5-3805-261-34_914

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
866

TM 5-3805-261-34 TRANSMISSION MAINTENANCE. 14-3. Planetary Group. (Sheet 3 of 6) REMOVAL 10. Install two 1/2-13NC eyebolts and nuts (Figure 14-36) in top of output flange in transmission. NOTE Weight of transmission is approximately 1500 lbs. Use adequate hoist and sling for lifting. Failure to follow this procedure could cause INJURY. If you are injured, seek medical aid immediately. 11. Install hoist and sling to two 1/2-13NC eyebolts and take up slack in sling. 12. Remove transmission stand mount- ing bolts. 13. Lift transmission off of trans- mission stand and position on repair stand with output flange facing upward. 14. Remove hoist and sling. 15. Remove two 1/2-13NC eyebolts and nuts. 16. Remove and discard preformed packings (21, 22 and 23, Figure 14-37) from planetary housing (25). 17. Remove two bolts (24) from planetary housing (25) in trans- mission case. Go to Sheet 4 Figure 14-36. Figure 14-37. 14-25

Privacy Statement
Press Release
Contact