ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_876

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_878

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
830

TM -3805-261-34 ENGIE MAINTENANCE. 13-8. Piston and Connecting Rod. (Sheet 12 of 12) INSTALLATION CAUTION Be sure that connecting rod bolts do not damage liner. 14. Insert items 12 thru 3 as an assembly (Figure 13-49) in cylinder liner. "V" mark on piston must be in alinement with "V" mark on cylinder block. Rest piston on oil ring. 15. Using piston ring compressor, install rings. Put piston into place while assistant guides items 12 thru 3 as an assembly into position on crankshaft. 16. Using clean oil, lubricate two bearings (12, Figure 13-50). 17. Using clean oil, lubricate cap (2), two nuts (1) and bolts (10) threads. Install and tighten to a 30 ft-lb torque. 18. Make a mark on each of two nuts (1) and bolts (10, Figure 13-51). Tighten two nuts (1) an additional 90 degrees. 19. Repeat steps 1 thru 8 for remain- ing piston and connecting rod assemblies. NOTE Return 130G Grader to original equipment condition. End of Task 13-51 Figure 13-49. Figure 13-50. Figure 13-51.

Privacy Statement
Press Release
Contact