ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_878

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_880

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
832

TM 5380-261-34 ENGINE MAINTENANCE. (cont) 13-9. Camshaft. (Sheet 2 of 5) REMOVAL 1. Turn crankshaft until "C" mark on the crankshaft gear is in alinement with the "C" mark on the camshaft gear (2, Figure 13-52). NOTE To keep the engine timing correct during removal and installation of the camshaft, follow the next step carefully. 2. Mark injection pump drive gear teeth and idler gear at location A. 3. Mark idler gear teeth and camshaft gear at location B. NOTE When the marks are in alinement with the "C" mark on the crankshaft and camshaft, the engine timing will be correct. 4. Remove four bolts (1) from camshaft gear (2, Figure 13-53). 5. Remove camshaft gear (2). 6. Bend two locks (4) away from bolts (3). 7. Remove two bolts (3), locks (4) and thrust plates (5). 8. Install 3/8-16NC forged eyebolt in end of camshaft (6, Figure 13-54). Go to Sheet 3 13-53 Figure 13-52. Figure 13-53. Figure 13-54.

Privacy Statement
Press Release
Contact