ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_852

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_854

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
806

TM 5-3805-261-34 ENGINE MAINTENANCE. 13-5. Crankshaft Main Bearings. (Sheet 7 of 12) INSPECTION (Front, Center and Rear Main Bearings) 14. Remove six bolts (1) and three items 3 and 4 as an assembly (Figure 13-22). 15. Remove plastigage. 16. Using micrometer, measure and record thickness of plastic gage. 17. Compare recorded measurements from step 16 with range of 0.0037 to 0.0068 inch. Replace crank- shaft if measurement falls outside this range. INSTALLATION (Front, Center and Rear Main Bearings and Thrust Bearings) 1. Install two new thrust bearings (5, Figure 13-17) on crankshaft journal of rear main bearing, fifth bearing from front. 2. Position three items 4 and 3 as an assembly (Figure 13-14) under crankshaft journal of rear main bearing, alining holes. 3. Coat six washers (2) and bolts (1) with clean engine oil and install finger tight. Figure 13- Go to Sheet 8 13-27 Figure 13-

Privacy Statement
Press Release
Contact