ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_849

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_851

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
803

TM 5-3805-261-34 ENGINE MAINTENANCE. (cont) 13-5. Crankshaft Main Bearings. (Sheet 4 of 12) REMOVAL (Front, Center and Rear Main Bearings and Thrust Bearings) (cont) CAUTION Crankshaft must be rotated in direction of normal engine rotation when removing main bearings. Engine rotation is counterclockwise when viewed from rear. Failure to follow this procedure could result in damage to block, crankshaft, or both. 11. Rotate crankshaft and tool against upper main bearings (6) in direction of normal engine rotation. 12. Remove and discard upper half of three main bearings (6, Figure 13-19). CLEANING Clean all parts. Refer to Chapter 2. INSPECTION (Front, Center and Rear Main Bearings) 1. Coat three new lower main bearings (4, Figure 13-20) with clean engine oil. 2. Install in crankshaft bearing caps (3) with bearing tab toward tab locator in block. Go to Sheet 5 13-24 Figure 13-19. Figure 13-20.

Privacy Statement
Press Release
Contact